10 Binderholz Bausysteme GmbH EDGE PROCESSING CLT BBS CLT BBS 125 During longitudinal profiling, CLT BBS 125 is chamfered as a standard on all four longitudinal edges (width of the chamfer is approx. 3 mm) before the cutting process is started. Edges created by machining remain sharp-edged. CLT BBS XL In CLT BBS XL components, the edges are not chamfered. PRESENTATION OF DRILLHOLES Drillholes on the top surface Green drillhole Drillhole extends through the entire strength of the component Red drillhole Drillhole on the viewed side, does NOT extend through the entire strength of the component Dashed drillhole Drillhole on the rear side, does NOT extend through the entire strength of the component Drillholes on the face (Ø 28 mm) - Applies only for CLT BBS XL - Length max. 1300 mm - Manual machining When positioning the drillholes deviations in measurements may occur.
RkJQdWJsaXNoZXIy NTQ5ODU5